All Brands
Dishwasher Repair in Las Vegas
Dirty dishes after a full cycle, standing water in the tub or a leak at the door each point to a different part. We test the dishwasher and name it.
Phones answered 24/7
Brands We Service
Houses, Condos, Rentals & Garages
How a Repair Visit Works
Related Services
Other appliance and brand repairs we handle in the south and southwest Las Vegas Valley.
Dishwasher Problems We Diagnose
Here are the dishwasher faults that come up most often, from drainage and fill problems to leaks, drying and latch failures.
- Not Cleaning Properly
- Not Draining
- Door Won't Close
- Making Unusual Noise
- Not Filling with Water
- Leaking Water
- Dishwasher Won't Start
- Leaving Residue on Dishes
- Not Cleaning Dishes Well
- Not Filling with Water
- Overfilling with Water
- Leaking from Door
- Leaking from Bottom
- Soap Dispenser Not Opening
- Rinse Aid Not Dispensing
- Dishes Not Drying Properly
- Heating Element Failure
- Spray Arms Clogged
- Spray Arm Not Spinning
- Wash Pump Failure
- Drain Pump Failure
- Mineral Scale Buildup
- White Spots on Dishes
- Cloudy Glassware
- Dishwasher Smells Bad
- Drain Filter Clogged
- Door Latch Failure
- Control Board Failure
- Cycles Running Too Long
- Stopping Mid-Cycle
- Error Code Displayed
- Grinding Noise from Pump
- Humming but Not Starting Cycle
- Water on Floor Under Dishwasher
- Rust Inside Dishwasher Tub
- Rack Tines Rusting
- Top Rack Not Cleaning
- Bottom Rack Not Cleaning
- Touchpad Not Responding
- Door Spring Broken
- Fills and Immediately Drains
- Running Constantly / Cycle Won't End
- Detergent Tablet Not Dissolving
- White Deposits on Plastic Containers
- Dishwasher Interior Rusting
- Cloudy Film Inside Tub
- Glassware Permanently Etched
- FH / Water Inlet Error (Whirlpool/KitchenAid)
- Leak Detection System Tripped
- Air Gap Clogged
- Garbage Disposal Connection Problem
- Hard Food Disposer Failed
- Starting Intermittently
- Exterior Too Hot to Touch
- Steam Escaping from Door
- Built-In Water Softener Not Working
- Food Particles on Dishes After Washing
- Salt Indicator Light On
- Child Lock Activated and Stuck
- Poor Results After Switching Detergent
- Not Using Hot Water at All
- Three-in-One Dishwasher Tablet Not Working Properly
- Knocking During Wash Cycle
- High-Temperature Wash Not Working
- Delay Start Feature Not Working
- Burning Smell from Dishwasher
- Control Panel Getting Wet
- Spray Arm Spin Test Failed
- Bottom Spray Arm Missing or Broken
- Third Rack Not Cleaning (Third-Rack Models)
- Not Filling with Enough Water
- Sanitize Indicator Not Illuminating
- Spray Arm Hitting a Dish During Cycle
- Steam Wash Option Not Working
- Cycle Selector Knob Broken
Dishwasher Brands We Service
Dishwasher Repair Questions
Straight answers to what people ask before booking. If your question isn't here, send it with your booking request and we'll answer it.
Still have questions?
We cover 15 ZIP codes in Enterprise, Spring Valley, Paradise and southern Henderson.
Start with the filter under the lower spray arm, which clogs with food and labels. If it is clean, check whether the drain hose has a kink or the garbage disposal knockout plug was never removed after a new install. When those are fine, the drain pump, its impeller or a check valve has usually failed and should be tested.
It is better not to. Small leaks under a built-in dishwasher tend to soak the subfloor and cabinet base before they show on the floor. Shut off the water supply valve under the sink, turn the machine off at the breaker or unplug it, and wipe up what you can. A technician can find whether the gasket, a seal or a hose connection is the source.
Possibly. Many newer machines, especially Bosch models, dry by condensation rather than a heater, so some moisture on plastics is normal. If glass and china are wet too, check that rinse aid is filled. Wet dishes plus lukewarm water at the end of the cycle point toward a failed element, thermostat or control.
Yes. We repair commercial dish machines such as Hobart units in addition to residential models. Commercial machines run different wash temperatures and have sanitizing requirements of their own, so tell us the make, the model and how the kitchen uses it when you book, and we can plan the visit around service hours.
Usually trapped food and grease in the filter, the sump or the door gasket folds, sometimes made worse by a drain hose without a high loop, which lets sink water seep back in. Clean the filter, wipe the gasket and run a hot empty cycle. If the smell returns quickly or water sits in the sump, a drain fault is likely and worth testing.
No. We are an independent repair company and are not factory-authorized by any manufacturer. If your dishwasher is still under the manufacturer's warranty, contact the manufacturer first, since work by an independent shop may not be covered. Out-of-warranty dishwashers get manufacturer-specified parts by default and a 90-day parts and 30-day labor warranty on the repair.
Dishwasher repair in the Las Vegas Valley
A dishwasher is a sealed tub with a pump, a heater, a few valves and a control board, and nearly every failure is about water: it does not get in, it does not get hot, it does not spray hard enough, or it does not get back out. Each of those has a short list of likely parts.
Hard valley water adds a layer of confusion. Mineral scale narrows spray arm jets, coats heaters and inlet screens and leaves white film on glasses, which can look like a mechanical fault when it is not. Our dishwasher repair visits separate water chemistry from broken parts before anything gets replaced.
When the dishes tell you something is wrong
Grit on the top rack, a cloudy film, cups that come out wet, or a puddle of gray water in the bottom are the reports we hear most. Others are louder: a grinding or humming pump, a door that will not latch, or a control panel that blinks and refuses to start.
Water on the floor needs quick attention, since leaks under a built-in can reach cabinets and flooring before anyone notices.
Typical failures inside the tub
Drain pumps jam on glass and seeds, filters clog, and check valves stick. Inlet valves weaken or scale up, float switches stick, and wash motors lose pressure. Heating elements and thermostats fail, which leaves dishes wet, and door latches and switches wear from daily use. Leaks usually come from a door gasket, a tub seal, a spray arm hub or a loose supply connection.
Dishwasher makes we service
Bosch, Miele and Thermador models are common in newer kitchens, alongside KitchenAid, Whirlpool, Maytag, GE, Samsung and LG. We also repair Fisher & Paykel DishDrawer units, panel-ready JennAir and Gaggenau models, and commercial Hobart machines in restaurants and bars.
From test cycle to fixed
Most dishwashers have a diagnostic or test cycle, and the technician uses it to run the fill, wash, drain and heat stages one at a time. Filters and sump are inspected, the suspect part is measured, and any stored code is read.
Then a single parts-and-labor price goes to you for approval. After the repair, the machine runs a cycle with us watching for leaks.
Why TrueFix for dishwashers
We answer every call at any hour, with no surcharge for nights or weekends. If there is space on the route we can often come the same day, but we will not promise it before checking. Parts follow the manufacturer's specification by default, and the work is backed by a 90-day parts and 30-day labor warranty.